5. Follow the procedures in
After Working Inside Your Computer
.
Removing The Memory
1. Follow the procedures in Before Working Inside Your Computer.
2. Remove the cover.
3. Press down on the memory retaining tabs on each side of the memory modules and lift the
memory module upwards to remove it from the computer.
Figure 1.
Installing The Memory
1. Align the notch on the memory-card with the tab in the system-board connector.
2. Insert the memory module into the memory socket.
3. Press down on the memory module until the securing clips secure the memory in place.
4. Install the cover.
5. Follow the procedures in
After Working Inside Your Computer
.
Removing The System Fan
1. Follow the procedures in
Before Working Inside Your Computer
.
2. Remove the:
– cover
– bezel
– hard drive
3. Follow the steps below to remove the system fan cables:
a) Disconnect the fan cable from the system board. [1]
b) Un-thread the system fan cable from the metal retention clips. [2,3]
19
To Next Page
Loading...
