Dell Wyse 3040 Thin Client - Configuring Bridge Network Connection

4. Require IPv4 addressing for this connection to complete — The IPv4 address is required to complete the
connection. If the IPv4 address is not available, then the connection is not congured.
5. Click the Routes button to edit IPv4 routes for Bond connection.
a. Click Add to add an IP address. After an IP is added, Netmask, Gateway and Metric specic to that IP
are displayed.
b. Select the check box if you want to ignore the automatically obtained routes.
c. Select this check box if you want to use your connection only for resources on that particular network.
• If Automatic (DHCP) addresses only method is selected, you must congure the following options:
1. DNS Servers — Type the IP addresses of domain name users that are used to resolve host names. Use
commas to separate multiple domain name server addresses.
2. Search domains — Type the IP addresses of domains that are used when resolving host names. Use commas
to separate multiple domains.
3. DHCP client ID — Enter the ID for the DHCP client. This client identier allows you to customize your
computer’s conguration.
NOTE: The other settings remain same as described in automatic (DHCP) method for IPv4
authentication.
• If Manual method is selected, you must congure the following options:
1. Click Add to add an IP address. After an IP is added, Netmask, Gateway specic to that IP are displayed.
2. DNS Servers — Type the IP addresses of domain name users that are used to resolve host names. Use
commas to separate multiple domain name server addresses.
3. Search domains — Type the IP addresses of domains used when resolving host names. Use commas to
separate multiple domains.
NOTE: The DHCP client ID option and Ignore automatically obtained routes check boxes are disabled.
The other settings remains the same as described in automatic (DHCP) method for IPv4 authentication.
• If Link-Local Only method is selected, the DNS Servers, Search domains, DHCP client ID, and Routes options are
disabled. You can select the Require IPv4 addressing for this connection to complete check box to allow the
connection to complete. The IPv4 address is required to complete the connection. If the IPv4 address is not
available, then the connection is not congured.
• If Shared to other computers method is selected, the DNS Servers, Search domains, DHCP client ID, and Routes
options are disabled. You can select the Require IPv4 addressing for this connection to complete check box to
allow the connection to complete. The IPv4 address is required to complete the connection. If the IPv4 address is
not available, then the connection is not congured.
d. Click the IPv6 Settings tab. From the drop-down list, select the following method type for IPv4 authentication. The
available options are:
• Ignore
• Automatic
• Automatic, addresses only
• Manual
• Link-Local Only
NOTE: The settings are same as conguring the IPv4 settings tab described in this section.
4. Add and congure the Bridge network connection for your thin client.
a. Click the Bridge tab, and congure the following options:
1. Interface name — Type the name for your network interface.
33