12 Chapter 3
Step 5: Verifying Thin Client Operation
After the thin client displays the WES7p desktop, you can verify the Version and that
your general client information is correct.
1. On the General tab of the Wyse Client Information window (Start > All Programs >
Wyse Client Information), verify the following:
• Version is 9.01 Build 850.
2. Click Close to close the Wyse Client Information window. The thin client is ready for
operation and setup by an administrator.
TIP: For security, automatic logon to a User desktop is enabled on the thin client by
default (and is a member of the User group; not a member of the Administrator
group). To log on as a different user or an administrator: Use the Log off button
(Start > Log off) to log off the current desktop while holding down the SHIFT key
until the Log On window displays. Log on as follows (passwords are case sensitive):
Administrators - default Username is administrator and default case-sensitive
Password is Wyse#123.
Users - default Username is user and default case-sensitive Password is Wyse#123.
Administrator and other documentation for your thin client model are available at:
http://www.wyse.com/manuals.
Step 6: Attach a Wyse Conversion Label and Microsoft License Label on Each Converted
Thin Client
The conversion kit is supplied with Wyse Conversion Labels and Microsoft License
Labels that must be attached to each thin client. Be sure you have purchased the
amount of labels you need.
CAUTION: Failure to install the label may cause delays in service and support. The
serial number must be given to a Customer Support Technician to validate entitlement
to support and service from Dell. Failure to do so will result in the original operating
system being loaded on the device and is in breach of your license agreement.
Figure 13 Placement of Wyse Conversion Label (blank example)
Figure 14 Placement of Microsoft License Label (blank example)
To Next Page
Loading...
Need help?
General
