4. Replace the four screws (M2.5x4) securing the display hinges to the palm-rest assembly and connect the camera cable to
the system board, adhering the tape securing the camera cable to the fans.
5. Align the screw hole on the wireless antenna and camera cable bracket to screw hole on the system board.
6. Replace the screw (M1.6x3) that secures the wireless antenna and camera cable bracket to the system board.
7. Connect the display cable to the system board.
8. Align the screw holes on the display-cable bracket with the screw holes on the system board.
9. Replace the two screws (M1.6x2.5) that secure the display-cable bracket to system board.
Post-requisites
1. Replace the battery.
2. Replace the base cover.
42
Replacing the display assembly
To Next Page
Loading...
