book.book Page 12 Monday, June 25, 2012 11:55 AM
3 Using a Phillips screwdriver, remove the screws beneath the system badge.
4 Using a T5 screwdriver, remove the screws from the base-cover assembly.
1 T5 screws (6) 2 screws (2)
5 Slide the tabs on the system badge into the slots on the base-cover assembly and
snap the system badge into place.
6 Starting from the back of the computer, pry the base-cover assembly, turn the
base-cover assembly over, and place it on the palm-rest assembly.
1 base-cover assembly 2 palm-rest assembly
12 | Removing the Base Cover
To Next Page
Loading...
