Dell XPS /Dimension - Configuring Graphics Cards

6. If you are installing a new floppy drive rather than replacing a drive, remove the front- panel inserts.

From inside the drive bay, gently press on each side of the insert until it pops out.
7. Check all cable connections, and fold cables out of the way to provide airflow for the fan and cooling vents.
8. Close the computer cover.

9. Connect your computer and devices to electrical outlets, and turn them on.
10. After you turn on your computer, press <F2> when you are prompted to enter setup mode.
11. Highlight Drive Configuration and press <Enter>.
12. Use the left and right arrows to change Diskette Drive A from Not Installed to 3.5 inch, 1.44 MB.
13. Press <Enter>.
14. Highlight Integrated Devices (LegacySelect Options) and press <Enter>.
15. Ensure that the Diskette Interface entry is set to Auto. If necessary, use the left and right arrows to set it to Auto.
16. Press <Enter>.
17. Press <Esc>.
18. Press <Enter> to Save changes and Exit.

The computer restarts.
19. See the documentation that came with the drive for instructions on installing any software required for drive operation.

CD/DVD Drive


Removing a CD/DVD Drive
1. Follow the instructions in "Before You Begin."
2. Open the computer cover.
3. Disconnect the power and CD/DVD drive cables from the back of the drive.

NOTICE: To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer.
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in your Owner's Manual.