Dell XPS /Dimension - Page 41


The following table shows Drive Configuration option information.


The following table shows Memory Information option information.


The following table shows CPU Information option information.


The following table shows Integrated Devices (Legacy Select Options) option information.


The following table shows Power Management option information.


The following table shows System Security option information.

Diskette Drive A:
Displays floppy drive details.
SATA Primary Drive:
Displays SATA primary hard drive (if installed). The default is Off.
SATA Secondary Drive:
Displays SATA secondary hard drive(if installed). The default is Off.
IDE Primary Drive 0:
Displays primary hard drive 0. The default is Auto.
IDE Primary Drive 1:
Displays primary hard drive 1 (if installed). The default is Off.
IDE Secondary Drive 0:
Displays secondary hard drive 0. The default is Auto.
IDE Secondary Drive 1:
Displays secondary hard drive device type. The default is Off.
IDE Drive UDMA:
Turns IDE Drive UDMA on and off. The default is On.
Option
Function
Installed System Memory
Displays the amount of installed system memory.
System Memory Speed
Displays the speed of your system memory.
System Memory Channel Mode
Displays the mode of your system memory.
AGP Aperture
Displays the amount of aperture memory. The default is 128 MB.
Option
Function
Hyper-Threading
Enables Hyper-Threading. The default is Disabled.
CPU Speed
Sets the CPU speed. The default is Normal.
Bus Speed
Displays the bus speed.
Processor 0 ID
Displays processor ID.
Clock Speed
Displays clock speed.
Cache Size
Displays cache size.
Option
Function
Network Interface Controller
Turns the network interface controller off and on. The default is On.
Mouse Port
Turns the mouse port off and on. The default is On.
USB Emulation
Turns USB emulation off and on. The default is On.
USB Controller
Turns the USB controller off and on. The default is On.
Serial Port 1
Sets serial port options and turns the port off and on. The default is Auto.
Serial Port 2
Sets serial port options and turns the port off and on. The default is Auto.
Parallel Port
Displays parallel port settings when <Enter> is pressed. The default mode is PS/2 and the I/O address default is 378h.
Diskette Interface
Sets diskette interface options. The default is Auto.
PC Speaker
Turns the PC speaker off and on. The default is On.
Primary Video Controller
Sets the primary video controller. The default is AGP.
Option
Function
Suspend Mode
Displays the suspend state used by the computer. The default is S3.
AC Power Recovery
Enables AC power recovery to occur. The default is Off.
Low Power Mode
Minimizes power use when the computer is off. The default is Disabled.