Adding and Replacing Parts 127
NOTICE: When the hard drive is not in the computer, store it in protective antistatic
packaging. See "Protecting Against Electrostatic Discharge" in the Product
Information Guide.
3
Slide the hard drive out of the computer.
4
Remove the new drive from its packaging.
Save the original packaging for storing or shipping the hard drive.
NOTICE: Use firm and even pressure to slide the drive into place. If you use
excessive force, you may damage the connector.
5
Slide the hard drive into the bay until it is fully seated.
6
Replace and tighten the screws.
7
If the new hard drive is not already pre-imaged, install the operating
system and drivers for your computer.
See
"Restoring Your Operating
System" on page 118 and "Reinstalling Drivers and Utilities" on page 116.
1 hard drive screws (2) 2 hard drive
2
1
To Next Page
Loading...
