HOT WATER PRODUCTION
1. Turn the appliance on by pressing the espresso coffee ON/OFF
button (fig. 8).
2. Place a container under the cappuccino maker.
3.When the temperature OK light comes on, press the coffee run-
off button (fig. 11) and at the same time turn the steam knob anti-
clockwise (fig. 21).Water comes out of the cappuccino maker;
4. To interrupt the flow of hot water, close the steam knob by rotating
clockwise and press the coffee button again.
Cleaning and maintenance
Before performing any cleaning or maintenance operations, turn
the machine off, unplug it from the power socket and allow it to
cool down.
1. Do not use solvents or detergents when cleaning the coffee
maker.A soft, damp cloth is sufficient.
2. Remove the filter-trays, empty them and wash them periodically.
ATTENTION: during cleaning, never immerse the unit in
water – it is an electrical appliance.
Cleaning the filter holder for ground coffee
About every 200 coffees, clean the filter holder of ground coffee as
follows:
• Remove the filter and frother by turning the filter holder upside
down and tapping;
• Clean the inside of the filter holder. Never wash in a dishwasher.
•Clean the metal filter thoroughly in hot water using a brush (fig.
23. Make sure the holes in the metal filter are not blocked. If
necessary, clean with a pin (see fig.24).
• Separate the two parts of the frother and rinse under hot water
(fig. 25).
• Replace the rubber diaphragm, making sure it adheres well to the
plastic support.
Failure to clean as described above invalidates the guarantee.
fig. 23
fig. 24
fig. 25
Coffee Maker
8
To Next Page
Loading...
