15
TILTING GRILL
■ The grill is secured to the rear wall of the oven on a hinge system that allows it to be
lowered to allow proper access when cleaning the oven ceiling (g. 11). The grill is held
in place by the side wire racks.
■ To lower the grill element: unscrew the xing screws and slide off the wire racks to the
oven wall as in g. 9a.
■ When you have nished cleaning the oven ceiling, raise the grill element and assem-
ble the wire racks on the oven walls using the 2 screws (g. 9a). Make sure that the
element is held securely in place.
■ The grill element itself is self-cleaning.
Stud
Figure 11
Figure 10
GREASE FILTER
■ A special screen is provided at the
back of the oven to catch grease par-
ticles, mainly when meat is being roa-
sted (g. 10).
■ Clean the lter after any cooking!
The grease lter can be removed for
cleaning and should be washed regu-
larly in hot soapy water (g. 10).
■ Always dry the lter properly before t-
ting it back into the oven.
CAUTION: When baking pastry etc. this
lter should be removed.
To Next Page
Loading...
