36
LIGHTS DISPLAYED POSSIBLE CAUSE REMEDY
FLASHING
The grinding is too ne and the coee is
delivered too slowly or not at all
Repeat coee delivery and turn the grinding
adjustment dial (A5) (g. 13) one click clockwise
towards "7" while the coee mill is in operation.
If after making at least 2 coees delivery is still
too slow, repeat the correction procedure, turn-
ing the grinding adjustment dial another click
until delivery is correct (see section “15.2 Adjust-
ing the coee mill”). If the problem persists, turn
the steam/hot water dial (A21) to the I position
and let some water run from the cappuccino
maker (A18).
If the water softener lter (C4) is present,
an air bubble may have been released in-
side the circuit, obstructing delivery
Deliver a little water from the cappuccino maker
(A18) by turning the steam/hot water dial (A21)
to the I position until the ow is regular (g. 5).
FLASHING
The coee beans have run out Fill the beans container (A3 -
g. 14
).
FLASHING ON
The pre-ground coee function has been
selected without placing any pre-ground
coee in the funnel (A4)
Place pre-ground coee in the funnel (
g. 17
) or
deselect the "pre-ground" function.
The pre-ground coee funnel (A4) is
clogged
Empty the funnel with the help of a brush as de-
scribed in section “19.8 Cleaning the pre-ground
coee funnel”.
FLASHING
The machine must be descaled The descaling procedure described in section
“20. Descaling” needs to be performed.
FLASHING
Too much coee has been used Select a milder taste by turning the dial (B6)
anticlockwise.
The water circuit is empty
Turn the steam/hot water dial (A21) to the I posi-
tion
until delivery stops, then bring it back to the
0 position. If the alarm occurs while hot water
or steam is being delivered, turn the dial to the
0 position.
Turn the steam/hot water dial to the I
position
until delivery stops, then bring it back to
the 0 position. If the problem persists, make sure
the water tank (A7) is fully inserted.
→
To Next Page
Loading...
