DeLonghi ECAM23 13 Series - Water Hardness, Technical Data, and Indicator Lights; Setting Water Hardness Levels; Technical Specifications; Explanation of Indicator Lights

35
Indicator paper Water
hard-
ness
Corresponding
setting
low
medium
high
maxi-
mum
21.2 Setting water hardness
1. Make sure the appliance is o (but connected to the mains
electricity supply and with the main switch (A6) in the I
position);
2. Press and hold the button (B5) for at least 5 seconds.
The , , and lights come on together;
3. Press the button (B2) to set the actual water hardness
(as measured by the indicator paper - see table in previous
section).
4. Press the / button (B9) to conrm the selection.
The machine is now reprogrammed with the new water hard-
ness setting.
22. TECHNICAL DATA
Voltage: See rating label
Absorbed power: See rating label
Pressure: 1.5MPa (15 bars)
Max. water tank capacity: 1.8 l
Size LxDxH: 240x440x360 mm
Cord length: 1150 mm
Weight: 9.2 kg
Max. beans container capacity: 250 g
23. EXPLANATION OF LIGHTS
LIGHTS DISPLAYED POSSIBLE CAUSE REMEDY
FLASHING
The steam/hot water dial must be turned
(A21)
Turn the steam/hot water dial
FLASHING
Insucient water in the tank (A7) Fill the tank with water and/or insert it correctly,
pushing it as far as it will go until it clicks into
place.
ON
The tank (A7) is missing or not correctly
in place
Insert the tank correctly, pushing it as far as it
will go until it clicks into place.
FLASHING
The grounds container (A13) is full Empty the grounds container and drip tray (A14),
clean and replace. Important: when removing the
drip tray, the grounds container must always be
emptied, even if it has not lled up appreciably. If
this is not done, when you make the next coees,
the grounds container may ll up more than ex-
pected and clog the machine.
ON
After cleaning, the grounds container
(A13) has not been replaced
Remove the drip tray (A14) and insert the
grounds container.
→