DeLonghi NESPRESSO VERTUO - Page 39

39
The machine doesn’t start and
the lights blinks irregularly.
• Fill the water tank and push buon to start.
• Check that handle is properly locked.
Lights blink while machine is
running.
• If coee or milk is flowing normally, this indicates the
machine is working properly.
• If only water is flowing, the machine is executing a user
request for either cleaning, descaling or emptying the
system. Refer to the corresponding paragraph in this user
manual.
Lights blink and machine is not
running.
• It will take some time before the coee flow comes out (due
to code reading and pre-weing the coee).
• Check that a fresh capsule is inserted in correct position,
that the handle is properly locked and push the buon to
start.
• Fill the water tank and push buon to start.
• Turn the machine to “OFF mode” by
pushing the coee buon for 3 seconds
and then push it again to turn the machine ON. Now wait
approximately 20 minutes to allow the machine to cool
down aer extensive use.
Lights blink irregularly.
Machine is not running.
• During regular Coee/Espresso preparation: 1) Unlock the
handle and open the machine head to check that a fresh
undamaged capsule is inserted in the correct position.
2) Check that the handle is in “LOCKED” position. 3) Check
that the water tank is filled.
• During Descaling, Emptying and Cleaning: 1) Check that
capsule is ejected. 2) Check that the handle is in “LOCKED”
position.
• During Programming Volume: 1) Check if a capsule has been
well inserted. 2) Please refer to the corresponding chapter.
• If problem persists:
1. Unlock the handle and open machine head.
2. Replace capsule (if needed).
3. Disconnect powercord from the outlet and plug the
machine back into outlet aer 10 seconds.
4. Close the head and press the buon to turn ON and press
again to start brewing. If problem persists, call Nespresso.
Descaling alert blinks or is fixed
orange.
• Machine triggers descaling alert according to your beverage
consumption. Descale the machine. Refer to section
“Descaling” according to your beverage consumption.
Rinse alert blinks orange. A rinsing cycle of the milk carafe is required, refer to section
“Milk Preparation & Daily rinsing”.
I cannot enter the Menu Mode
(Reset to factory seings/
Emptying the system before
a period of non-use/Water
hardness seing).
• Be sure to remove the milk carafe from the connector door.
• Be sure that the descaling pipe is not connected to the
connector door.
• Press and hold hot foam buon until descale and
rinse alerts blink.