DeLonghi PACAN285 - Troubleshooting Guide; Unit Does Not Start; Unit Works for Short Time; Insufficient Cooling

12
Start of season checks
Make sure the power cable and plug are undamaged and
the ground connection is ecient. Follow the installation
instructions precisely.
End of season operations
To drain all water from the circuit, remove the external cap by
unscrewing it in the anticlockwise direction then, remove the
internal cap from the drainage hose 10 on the back of the
appliance and allow the water to drain out into a basin (gure
M).
When the appliance is empty, replace the caps.
Clean the lter and dry thoroughly before putting back.
When the appliance is empty, replace the caps.
Clean the lter and dry thoroughly before putting back.
TECHNICAL SPECIFICATION
Power supply voltage see rating label
Max. absorbed power
during air conditioning “
Refrigerant “
Cooling capacity “
LIMIT CONDITIONS
Room temperature for
air conditioning 64 ÷ 104°F 18 ÷ 40°C
Transport, lling, cleaning, recovery and disposal of
refrigerant should be performed by a technical service
centre appointed by the manufacturer only.
The appliance should be disposed of by a specialist centre
appointed by the manufacturer only.
TO AVOID DAMAGE TO THE UNIT:
NEVER TRANSPORT OR TURN THE APPLIANCE UPSIDE DOWN OR
ON ITS SIDE. IF THIS OCCURS, WAIT 6 HOURS BEFORE TURNING
THE APPLIANCE ON, 24 HOURS IS RECOMMENDED. After the unit
has been on its side, oil needs to return to the compressor to en-
sure proper function. Without allowing the unit this time (6-24
hours) the unit may function for only a short time, and then the
compressor will break down from lack of oil.
ELECTRICAL CONNECTION
This appliance is equipped with a 3 prong grounded plug. The
plug must be connected into an outlet that is properly installed
and grounded in the accordance with all local codes and ordi-
nances. Do not modify the plug provided with the appliance.
If it will not t the outlet, have a proper outlet installed by a
qualied electrician or relocate the unit to a proper outlet. If the
household electrical supply does not meet the above specica-
tions, or if you are not sure your home has an eective electrical
ground, have a qualied electrician or your local electrical utility
company check it and correct any problems.
SAFETY PLUG
The appliance is tted with a safety plug to protect the power
cable.
If power is cut o, unplug from the outlet and make sure the
power cable is undamaged.
If the cable is damaged, call the service center immediately.
If power cuts o frequently and the power cable is undamaged,
contact a qualied electrician.
OPERATION OF THE SAFETY PLUG
If the safety device incorporated in the plug trips and cuts o
the power supply, check that the power cable and plug are not
damaged.
If the power cable is undamaged, to restore operation press the
“RESET” button.
To verify correct operation of the plug, press the “TEST” button
periodically and make sure the appliance disconnects. If this is
not the case, contact the service center.
To restore operation, press the “RESET” button.
M