2. Attach four screws to the wall using the screw-locator pattern in figure 6. Photocopy the
pattern to use as a template. Use screws with head sizes small enough to fit in the
center of each of the four holes but large enough not to pop out of the elongated
sections. Leave 1/8 inch of the screw shanks behind the heads sticking out of the wall.
3. Tilt the antenna fully back on the base. Place the antenna base on the four screw heads
with the antenna pivot at the top. and pull down approximately 1/4 inch until the base is
firmly secured. Note that the XM logo will be upside down when the antenna is properly
installed.
4. Tilt the antenna away from the wall/base until the signal is optimized.
Note: Do not cut the antenna cable and attempt to splice it or attach alternative connec-
tors or cable. The cable and connectors used in your SKYFi
TM
Home Adapter Kit are
specially chosen and attached at the factory to ensure that they will work with XM’s unique
frequency band. Use an XM-approved extension kit (Deplhi model number SA10006) with
your SKYFi
TM
system.
Photocopy this diagram of the
screw-locator pattern on the
bottom of your XM Antenna to
use as a template for wall
attachment.
Using the SKYFi
TM
Audio System
Once the SKYFi
TM
Audio System is set-up and the SKYFi
TM
Receiver installed, the com-
plete set-up can be controlled as described in the SKYFi
TM
Operating Guide.
Unique SKYFi
TM
Audio System features include the following:
Volume
Volume can be adjusted using the volume knob on the SKYFi
TM
Audio System. In addition, when the SKYFi
TM
Receiver is connected
to the Audio System, the + and – controls on the remote control can
also be used to increase (+) and decrease (-) the volume.
If you also use your SKYFi
TM
Receiver with a vehicle adaptor kit or home adaptor kit, the
SKYFi
TM
Receiver will remember the volume level previously set when connected to the
Audio System and return to that setting the next time the Audio System is used.
8
To Next Page
Loading...
Need help?
General
