c. Swivel mount:This mount allows you
to adjust the angle of your SKYFi2
Vehicle Adapter after it is installed.
This mount uses a strong adhe-
sive that is not easily repositioned
when installed, so use care when
choosing the location of and placing
the mount. Do not install this mount
on a leather surface. Install the
mount only if the temperature is at
least 60°F.
– Clean the mounting surface with
the enclosed surface preparation
cleaning kit. Wipe the towelette
in one direction only. Do not
wipe the surface in a circular
on. Remove the liner from the
adhesive pad and adhere to the
vehicle’s surface. Make sure you
accurately place the pad on the
first try since in many cases it will
bond almost immediately. For
best results, do not touch or apply
pressure to the vehicle mount for
72 hours.
motion or back and forth. Dry the
area with a clean, dry cloth.
Repeat the cleaning process.
Allow to air dry thoroughly.
– Clean the same surface with the
enclosed alcohol prep pad. Wipe
in one direction only. Dry the
area with a clean, dry cloth.
Allow to air dry thoroughly.
– Warm the vehicle mount adhesive
pad by using a hair dryer or by
placing the vehicle mount on top
of the vehicle’s defrost outlet for
several minutes with the heater
9
English Skyfi2 install guide:SKYFi2 install guide layout 9/21/2006 12:09 PM Page 10
To Next Page
Loading...
Need help?
General
