3-2
Navigation Audio System
Finding a Station
BAND: Press this hard key to access the BAND screen and to switch between AM, FM1, FM2, XM1, and
XM2, if equipped.
Tuning Knob:
Use the tuning knob on the lower left corner of the navigation system to choose a radio
station.
SEEK : Press the SEEK up or the down arrow to go to the next or previous station and stay there.
To scan stations, press and hold the SEEK up or down arrow for two seconds until you hear a beep. The radio
will go to a station, play for a few seconds, then go on to the next station. Press either SEEK arrow again to
stop scanning. To scan preset stations, press and hold the SEEK up or down arrow for more than four sec-
onds. You will hear two beeps and PSCAN will be displayed, along with the highlighted preset. The radio will
go to one of the preset stations, play for a few seconds, then go on to the next preset station. Press either
SEEK arrow again to stop scanning presets.
The radio will only seek and scan stations with a strong signal that are in the selected band
TUNE
To Next Page
Loading...
Need help?
General
