1-5
Overview
Setting Radio Station Presets
1. Press the power/volume knob to turn the audio and navigation system on.
2. Press the BAND hard key to access the band menu and select the desired band. You may choose
between AM, FM1, FM2, and XM1, and XM2 (if equipped).
3. Use the tuning knob or the SEEK hard key arrows to select a station.
4. Touch and hold one of the six screen buttons at the bottom of the screen until you hear a beep or see
the station displayed on the selected preset button.
Setting the Time
1. Press the power/volume knob to turn the audio and navigation system on.
2. Press the CONFIG hard key.
3. Touch the Clock screen button.
4. Touch the appropriate Time Zone screen button.
5. Touch the Daylight Savings screen button (when applicable).
The time is now set. Touch the Manual Adjust screen button if you need to further adjust the time. The radio
will use the GPS satellite to set the time. The vehicle needs to be in an open area to receive the signal.
To Next Page
Loading...
Need help?
General
