RS-232/485 Converter CON-768 (Rev 3.3) Installation & Application Guide
Page 6 of 7 Document Edition 1.4
Transmitting the Upgrade File
1. Click the Query button to confirm communications with the controller and determine the current
firmware in the device.
2. Click the Program button. (Depending the version you are upgrading to/from a flash lock with
sufficient upgrade counts may be required before Flashloader will allow you to upgrade the panel.)
3. The Flash Loader transmits the new firmware. The Status and Progress fields indicate the current
upgrade operation. Once the upgrade is complete the Status field will show Upgrade Completed.
For more detailed information on the Delta Flash Loader refer to the Flash Loader Users Guide.
Compliance Declarations
FCC Compliance Information
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual,
may cause harmful interference to radio communications. Operation of this equipment in a residential area is
likely to cause harmful interference in which case the user will be required to correct the interference at his
own expense.
Industry Canada Compliance Statement
ICES-003 This Class A digital apparatus meets all requirements of the Canadian Interference-Causing
Equipment Regulations
Cet appareil numérique de la Classe A Respecte toutes les exigences du Règlement sur le matérial
brouiller du Canada.
UL Compliance Information
This product conforms to the following UL requirements:
• UL916: Energy Management Equipment
• CAUTION – Risk of Electric Shock – More than one disconnect switch may
be required to de-energize the equipment before servicing
• All terminals are acceptable for Class 2 circuit connection only
• CAUTION – Input Class 2 Power Supplies are interconnected. To Reduce
the Risk of Fire or Electric Shock, Use only Class 2 sources Suitable for
Interconnection
• Use Copper Conductor Only
• Select an external power supply that is certified for safety for the correct
destination country and that has an output rating, which is considered an NEC
Class 2 or Limited Power Source with the rating not to exceed 30 V rms, 42.4
V peak, 100 VA.
To Next Page
Loading...
Need help?
General