Chapter 1 Unpacking Check and Model Explanation
400V series
(1) Servo drive
(2) Servo motor
(3) 3 PIN Terminal Block (for R, S, T) (available for 750W ~ 1.5kW models)
(4) 3 PIN Terminal Block (for DC24V, DC0V, ) (available for 750W ~ 1.5kW models)
(5) Terminal Block (for DC24V, DC0V, R, S, T) (available for 2kW ~ 7.5kW models)
(6) 3 PIN Quick Connector (for U, V, W)
(7) 3 PIN Quick Connector (for P , D, C)
(8) One operating lever (for wire to terminal block insertion)
(9) One jumper bar (installed at pins P and D of the 3 PIN Terminal Block for P , D, C)
(10) Instruction Sheets (Multilingual version)
Part II : Optional parts (Refer to Appendix A)
(1) One power cable, which is used to connect servo motor to U, V, W terminals of servo
drive. This power cable includes a green grounding cable. Please connect the green
grounding cable to the ground terminal of the servo drive.
(2) One encoder cable, which is used to connect the encoder of servo motor to the CN2
terminal of servo drive.
(3) CN1 Connector: 50 PIN Connector (3M type analog product)
(4) CN2 Connector: 20 PIN Connector (3M type analog product)
(5) CN3 Connector: 6 PIN Connector (IEEE1394 analog product) for general communication
(RS-485)
(6) CN4 Connector: 4 PIN Connector (USB Type B product)
(7) CN6 Connector: RJ45 Connector for high-speed communication (CANopen)
1-2 Revision January 2011
Call 1(800)985-6929 for Sales
Call 1(800)985-6929 for Sales
To Next Page
Loading...
Need help?
General
