EasyManuals Logo

Delta Elektronika SM 700 Series User Manual

Delta Elektronika SM 700 Series
20 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #19 background imageLoading...
Page #19 background image
DELTA ELEKTRONIKA BV SM1540-D SM7020-D SM3004-D
Page 4 - 8 OPERATING MAINTENANCE TROUBLE SHOOTING CALIBRATING 1989 rev. May 2008
CALIBRATION
1) GEN ERAL
The power supplies are factory cali-
brated and nor mally need no further
cal i bra tion.
2)
METER CAL I BRA TION
DIG I TAL ME TERS
The zero indication can be calibrated
with R712 and R716, the full scale in di-
cation can be calibrated with R706 and
R708 on P388 (fig. 4 - 23).
3)
SPE CIAL CAL I BRA TIONS
The fol low ing cal i bra tions must be
done by qual i fied per son nel only.
Wrong cal i bra tion causes mal func tion.
These cal ibrations are only needed af -
ter spe cial re pairs.
Warn ing ! Dam age caused by wrong
cal i bra tion is not war ranted.
CAL I BRAT ING MAX. CUR RENT
RANGE or CAL IBRATING CC MONI-
TOR FULL SCALE.
The max. out put cur rent can be cali-
brated with R686. R686 is lo cated on
P385, P386 or P387. See fig. 4 - 24.
Program CC in put with exactly 5.00 V.
Set output voltage to a low value, en -
suring the power supply is in CC mode.
Measure the output cur rent with an ac -
curate shunt. Cal ibrate the cur rent with
R686 ex actly on the rated max. cur -
rent.
Warn ing! Wrong calibration can dam -
age the unit.
CAL I BRAT ING THE CC MON I TOR
OFF SET.
With R652 on P384 the offset of the CC
mon i tor volt age can be cal i brated. See
fig. 4 - 25. The unit has to be un loaded,
the out put voltage set on a low value.
Measure the offset voltage of the CC
mon i tor on the prog. con nec tor. Cal i -
brate the off set on a neg ative value be -
tween –10 mV and zero mV.
Warn ing! wrong cal i bra tion can
damage the unit.
SPARE PARTS
When or dering spare parts please
state: Model, Se rial num ber, Compo-
nent num ber and Com ponent de scrip-
tion.
ex am ple:
Model SM7020-D
Se rial no................814605900112
Com po nent no. .....D402
Com po nent descr..BYV52-PI-200
fig. 4 - 23 Me ter cal ibration with 25-turn potmeters on P388
fig. 4 - 24 Calibrating max cur rent P385, P386 or P387
fig. 4 - 25 After lifting P384, CC monitor can be calibrated

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Delta Elektronika SM 700 Series and is the answer not in the manual?

Delta Elektronika SM 700 Series Specifications

General IconGeneral
BrandDelta Elektronika
ModelSM 700 Series
CategoryPower Supply
LanguageEnglish

Related product manuals