Delta-q IC650 - Page 21

21
8.0 IC650 Conguration
There are two ways to alter the conguration on the IC650 Charger:
1. Use the Select Charge Prole Button.
2. Use a pre-programmed USB ash drive.
Figure 27. Press the Select Charge Prole Button
to advance through the charge proles. When the
desired charge prole appears, hold the button for
10 seconds to conrm your selection.
1. Disconnect AC input from the charger, or from the
wall outlet. Wait 30 seconds for the input relay to
open.
2. While reconnecting AC input, press and hold the
Select Charge Prole Button. Hold the button
until Error Indicator is on and Battery Charging
Indicator starts ashing.
3.
3. Press and release the Select Charge Prole Button
to advance through charging proles loaded on
the charger. The selected charging prole will
be displayed up to three times (e.g. “P-0-1-1” for
Prole 11).*
*Process will time out and prole will remain
unchanged if there is 15 seconds of inactivity, a
prole number is allowed to display three times, or if
AC power is cycled.
4. Once the desired charging prole is displayed,
press and hold the button for 10 seconds (see
Figure 3) to conrm selection and exit Prole
Selection Mode.
5. Press the Select Charge Prole Button to check
that the desired prole is selected.
Figure 28.Disconnect AC input from the charger.
Figure 29.Reconnect AC input while holding the Select
Charge Prole Button.
8.1 Selecting A Charge Prole Using the ‘Select Charge Prole Button’