Need help?Do you have a question about the Delta 23-580 and is the answer not in the manual?
Learn tool applications, limitations, and specific hazards before use.
Always wear safety glasses or goggles to protect eyes during operation.
Ensure tools are plugged into grounded receptacles or use adapters with proper grounding.
Remove keys/wrenches; ensure switch is OFF before plugging in.
Use correct wheels, never chipped/cracked; ensure guards/shields are secure.
Keep tool rest 1/8" or less from wheel; adjust as wheel wears.
Grind on face only, avoid flammable areas, use correct speed wheels.
Use wheels rated for 3600 RPM or higher, 5" diameter with 1/2" arbor holes.
Use a separate circuit with #12 wire and a 20 Amp fuse; ensure correct voltage.
Grinder is wired for 110-120 volt, 60 Hz AC. Ensure correct voltage matches motor.
Plug into a matching, properly installed, and grounded outlet. Do not modify plug.
Temporary adapters may be used for 2-pole receptacles if properly grounded.
Use dresser to shape wheel face and corners for optimal performance.
Remove covers, use wedge to prevent shaft rotation, loosen/tighten arbor nut.
To Next Page
General
