1.1 Corresponding replacement models
The DOP-100 series models support conversion from the DOP-B series models, as shown in the
following table. When you use a DOP-100 series model to open a project file of the
corresponding DOP-B series model, the software automatically converts it to the DOP-100 series
model project. For example, if you use DOPSoft 4.0 to open a project file edited on
DOP-B03S210, it automatically converts the project file to that of the corresponding model
DOP-103BQ.
Compatible models indicate that the DOP-100 series models are the same as the DOP-B series
models in terms of the mounting dimensions and number of COM ports. Partially compatible
models indicate that the mounting dimensions are the same, but the number of COM ports is
different
*1
, so you need to note the number of COM ports when selecting the suitable model for
transition. Incompatible models indicate that there is currently no corresponding model for
transition, and the compatible models will be released in Q2 2019.
Note:
1. In the partially compatible models, the DOP-B series has three physical COM ports, while the DOP-100
series has two physical COM ports. The replacement model DOP-107IV (coming soon) for
DOP-B07S415 and DOP-B07E415 has three physical COM ports.
To Next Page
Loading...
Need help?
General
