Need help?Do you have a question about the Delta E8 BDI and is the answer not in the manual?
General| Series | E8 |
|---|---|
| Output Frequency | 0~600 Hz |
| IP Rating | IP20 |
| Cooling Method | Forced air cooling |
| Output Voltage | 0~Input Voltage |
| Control Method | SVC, V/F |
| Overload Capacity | 150% rated current for 60 seconds |
| Braking Unit | Built-in braking unit for models ≤ 30kW |
| Communication | Modbus RTU, CANopen |
| Protection Functions | Over-voltage, Under-voltage, Over-current, Overload, Overheat, Short-circuit |
| Operating Temperature | -10°C to +50°C (derating above 40°C) |
| Humidity | Less than 95% RH (non-condensing) |
| Altitude | Up to 1000m (derating above 1000m) |
Defines DANGER, WARNING, CAUTION, NOTICE, and INFORMATION symbols used in the manual to convey hazard levels and information.
Outlines critical safety precautions for installation, service, and operation, including electrical hazards, PV array safety, and qualified personnel requirements.
Explains the context of renewable energy, the inverter's function, and system configuration aspects like stringing and transformerless design.
Describes the integrated interface for operation monitoring, status, and fault signaling, enabling data downloading for analysis.
Details the inverter's MPP tracking, casing, heat dissipation, internal control, AC grid monitoring, and electrical isolation features.
Explains the inverter's operating temperature range and how ambient temperature affects output power through a derating curve.
Presents the voltage range for PV input for different Ex_BDI series models and the non-operating range.
Shows efficiency plots for the E10_BDI inverter at various input voltages and operating modes, including PV to AC and EV to AC.
Provides a detailed exterior view and description of the main components of the Ex_BDI series inverter.
Illustrates the location of the type label and describes the main caution labels provided on the inverter in English and French.
To Next Page
