EasyManuals Logo

Delta M80U User Manual

Delta M80U
130 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #24 background imageLoading...
Page #24 background image
The chapter contains instructions for
(1) Mechanical installation
(2) Electrical Installation
(3) Communication setup
Figure 3-1 shows the hoisting hook instruction.
Figure 3-2 provides the mechanical dimensions of the inverter.
3 Installation
- In some locations, mounting the inverter in direct sunlight may cause the inverter
to enter a thermal derating mode. To eliminate this concern, a shade structure
over the inverter chassis may be necessary.
CAUTION !
WARNING !
- Do not install the unit near or on flammable surfaces.
- Inverter must be mounted securely to a solid / smooth surface.
This unit is designed to be wall-mounted per Section 3.1.1 or Tilt Mounted per
Section 3.1.2.
Refer to Figures 3-3 through Figures 3-15.
1. Ensure the surface to which the unit is to be mounted is sufficiently strong
enough to carry the weight.
2. Orient the wall bracket (Figure 3-4, Figure 3-5 or Figure 3-7, Figure 3-8)
horizontally (perpendicular to the floor), with the large plate at the bottom,
and mark required mounting hole locations per Figure 3-6 or Figure 3-9.
3. Secure the mounting bracket on the wall with at least 8 5/16” (M8) screws.
4. Hang the inverter on the wall mounting bracket.
5.
Secure the inverter by inserting and tightening four screws (item 6, Figure 2-1)
as shown in Figure 3-15.
3.1 Mechanical Installation
3.1.1 Vertical wall mount
24
Installation

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Delta M80U and is the answer not in the manual?

Delta M80U Specifications

General IconGeneral
BrandDelta
ModelM80U
CategoryInverter
LanguageEnglish

Related product manuals