Delta VFD1A5MS43ANSAA User Manual

Chapter 7 Optional AccessoriesMS300
146
File Copy Setting Fault Description:
These faults occur when KPC-CC01 cannot perform the command after clicking the ENTER key in the
copy function.
LCD Display
Fault Name
Description
Corrective Actions
Read only
(ERR1)
Parameter and file are
read-only
The parameter/file is read-only and cannot
be written to.
1. Verify the specification in the user
manual.
If this solution does not work, contact your
local authorized dealer for assistance.
Write in error
(ERR2)
Fail to write
parameter and file
An error occurred while writing to a
parameter/file.
1. Check for any problem on Flash IC.
2. Shut down the system, wait for ten
minutes, and then restart the
system.
If this solution does not work, contact your
local authorized dealer for assistance.
Drive operating
(ERR3)
AC motor drive is in
operating status
A setting cannot be changed while the
motor drive is in operation.
1. Verify that the drive is not in
operation.
If this solution does not work, contact your
local authorized dealer for assistance.
Parameter locked
(ERR4)
AC motor drive
parameter is locked
A setting cannot be changed because a
parameter is locked.
1. Check if the parameter is locked. If it
is locked, unlock it and try to set the
parameter again.
If this solution does not work, contact your
local authorized dealer for assistance.
Parameter
changing
(ERR5)
AC motor drive
parameter is changing
A setting cannot be changed because a
parameter is being modified.
1. Check if the parameter is being
modified. If it is not being modified,
try to change that parameter again.
If this solution does not work, contact your
local authorized dealer for assistance.
Fault code
(ERR6)
Fault code is not
cleared
A setting cannot be changed because an
error has occurred in the motor drive.
1. Check if an error occurred in the
motor dive. If there is no error, try to
change the setting again.
If this solution does not work, contact your
local authorized dealer for assistance.
Warning code
(ERR7)
Warning code is not
cleared
A setting cannot be changed because of a
warning message given to the motor
drive.
1. Check if there is a warning message
given to the motor drive.
If this solution does not work, contact your
local authorized dealer for assistance.

Delta VFD1A5MS43ANSAA Specifications

General

Brand	Delta
Model	VFD1A5MS43ANSAA
Category	DC Drives
Language	English