Chapter 12 Descriptions of Parameter SettingsMS300
442
Analog input selection (AVI)
Analog input selection (ACI)
Full-load current for induction motor 1 (A)
Rated speed for induction motor 1 (rpm)
Number of poles for induction motor 1
Setting 03: Fan
The following table lists the relevant fan setting application parameters.
Master frequency command source
(AUTO, REMOTE)
2 (External analog input)
Operation command source
(AUTO, REMOTE)
Master frequency command source
(HAND, LOCAL)
Operation command source
(HAND, LOCAL)
Motor 1 maximum operation frequency
Rated / base frequency of motor 1
Rated / base voltage of motor 1
Mid-point frequency 1 of motor 1
Mid-point voltage 1 of motor 1
Mid-point frequency 2 of motor 1
Mid-point voltage 2 of motor 1
Minimum output frequency of motor 1
Minimum output voltage of motor 1
Output frequency upper limit
Output frequency lower limit
2 (V/F curve to the power of 2)
Multi-function input command 5 (MI5)
16 (Rotating speed command from ACI)
Multi-function output 2 (MO1)
11 (Malfunction indication)
Multi-function output 3 (MO2)
1 (Indication during RUN)
To Next Page
Loading...
Need help?
General