Chapter 12 Descriptions of Parameter SettingsMS300
447
2 (Fan is ON when the AC motor drive
runs; fan is OFF when the AC motor drive
stops)
Setting 10: Logistics
The following table lists the relevant logistics setting application parameters.
Master frequency command source
(AUTO, REMOTE)
7 (Digital keypad potentiometer knob)
Operation command source
(AUTO, REMOTE)
Motor 1 maximum operation frequency
Rated / base frequency of motor 1
Rated / base voltage of motor 1
Mid-point voltage 1 of motor 1
Mid-point voltage 2 of motor 1
Minimum output voltage of motor 1
Mid-point frequency 1 of motor 1
Minimum output frequency of motor 1
S-curve for acceleration begin time 1
S-curve for acceleration arrival time 2
S-curve for deceleration begin time 1
S-curve for deceleration arrival time 2
Over-current stall prevention during
acceleration
Over-current stall prevention during
operation
Acceleration / deceleration time selection
for stall prevention at constant speed
2: By the second acceleration / deceleration
time
Automatic voltage regulation (AVR)
function
Setting 11: Tension PID
The following table lists the relevant tension PID setting application parameters.
Master frequency command source
(AUTO, REMOTE)
To Next Page
Loading...
Need help?
General