Chapter 12 Descriptions of Parameter SettingsMS300
446
Minimum output frequency of motor 1
Minimum output voltage of motor 1
S-curve for acceleration begin time 1
S-curve for acceleration arrival time 2
S-curve for deceleration begin time 1
S-curve for deceleration arrival time 2
Analog input selection (AVI)
AVI terminal input selection
Setting 08: Textiles
The following table lists the relevant textile setting application parameters.
Master frequency command source
(AUTO, REMOTE)
1 (RS-485 communication input)
Operation command source
(AUTO, REMOTE)
Motor 1 maximum operation frequency
Rated / base frequency of motor 1
Rated / base voltage of motor 1
Mid-point frequency 1 of motor 1
Mid-point voltage 1 of motor 1
Mid-point frequency 2 of motor 1
Mid-point voltage 2 of motor 1
Minimum output frequency of motor 1
Minimum output voltage of motor 1
S-curve for acceleration begin time 1
S-curve for acceleration arrival time 2
S-curve for deceleration begin time 1
S-curve for deceleration arrival time 2
Over-current stall prevention during
acceleration
Over-current stall prevention during
operation
Over-torque detection level (motor 1)
To Next Page
Loading...
Need help?
General