Chapter 12 Descriptions of Parameter SettingsMS300
445
S-curve for acceleration begin time 1
S-curve for acceleration arrival time 2
S-curve for deceleration begin time 1
S-curve for deceleration arrival time 2
Multi-function input command 3 (MI3)
1 (Multi-step speed command 1)
Multi-function input command 4 (MI4)
2 (Multi-step speed command 2)
Multi-function output 1 (RY1)
11 (Malfunction indication)
Multi-function output 2 (MO1)
1 (Indication during RUN)
Multi-function output 3 (MO2)
2 (Operation speed reached)
Analog input selection (AVI)
Over-voltage stall prevention
Over-current stall prevention during
acceleration
Over-current stall prevention during
operation
Acceleration / deceleration time selection
for stall prevention at constant speed
0 (By current acceleration / deceleration
time)
DC brake frequency at STOP
Automatic voltage regulation (AVR) function
Setting 07: Packing
The following table lists the relevant packing setting application parameters.
Master frequency command source
(AUTO, REMOTE)
Operation command source
(AUTO, REMOTE)
2 (RS-485 communication input)
Two-wire / three-wire operation control
1 (two-wire mode 1, power on for operation
control (M1: FWD / STOP, M2: REV /
STOP))
Motor 1 maximum operation frequency
Rated / base frequency of motor 1
Rated / base voltage of motor 1
Mid-point frequency 1 of motor 1
Mid-point voltage 1 of motor 1
Mid-point frequency 2 of motor 1
Mid-point voltage 2 of motor 1
To Next Page
Loading...
Need help?
General