Delta VFD2A8MS21ANSAA User Manual

Chapter 12 Descriptions of Parameter SettingsMS300
360

06-06
Over-Torque Detection Selection (Motor 1)
Default: 0
Settings
0: No function
1: Continue operation after over-torque detection during constant speed
operation
2: Stop after over-torque detection during constant speed operation
3: Continue operation after over-torque detection during RUN
4: Stop after over-torque detection during RUN

06-09
Over-Torque Detection Selection (Motor 2)
Default: 0
Settings
0: No function
1: Continue operation after over-torque detection during constant speed
operation
2: Stop after over-torque detection during constant speed operation
3: Continue operation after over-torque detection during RUN
4: Stop after over-torque detection during RUN
 When you set Pr.06-06 and Pr.06-09 to 1 or 3, a warning message displays but there is no error
record.
 When you set Pr.06-06 and Pr.06-09 to 2 or 4, an error message displays and there is an error
record.

06-07
Over-Torque Detection Level (Motor 1)
Default: 120
Settings
10–250% (100% corresponds to the rated current of the drive)

06-08
Over-Torque Detection Time (Motor 1)
Default: 0.1
Settings
0.1–60.0 sec.

06-10
Over-Torque Detection Level (Motor 2)
Default: 120
Settings
10–250% (100% corresponds to the rated current of the drive)

06-11
Over-Torque Detection Time (Motor 2)
Default: 0.1
Settings
0.1–60.0 sec.
 When the output current exceeds the over-torque detection level (Pr.06-07 or Pr.06-10) and also
exceeds the over-torque detection time (Pr.06-08 or Pr.06-11), the over-torque detection follows
the setting of Pr.06-06 and Pr.06-09.
 When you set Pr.06-06 or Pr.06-09 to 1 or 3, an ot1 / ot2 warning displays while the drive keeps
running after over-torque detection. The warning remains on until the output current is smaller
than 5% of the over-torque detection level.

Delta VFD2A8MS21ANSAA Specifications

General

Brand	Delta
Model	VFD2A8MS21ANSAA
Category	DC Drives
Language	English