Delta VFD450C43S-21 - Page 564

Chapter 12 Descriptions of Parameter SettingsC2000 Plus
12.1-03-19
 When Pr.03-29 ≠ 0, the voltage input to ACI terminal is 0–10 V or 0–20 mA, and the Pr.03-19 is
invalid.
 When the setting is 1,2, or 4, the keypad displays the warning code “ANL”. It keeps blinking until
the ACI signal is recovered.
 When the drive stops, the condition that causes the warning does not exist, so the warning
automatically disappears.
 The ACI (4–20 mA) signal loss level is 3.6 mA, and the return level is 4 mA.

03-20
AFM1 Multi-Function Output 1

03-23
AFM2 Multi-Function Output 2
Default: 0
Settings
0
–25
Function Chart
Settings Functions Descriptions
0 Output frequency (Hz) Maximum frequency Pr.01-00 is processed as 100%.
1 Frequency command (Hz) Maximum frequency Pr.01-00 is processed as 100%.
2 Motor speed (Hz) Maximum frequency Pr.01-00 is processed as 100%.
3 Output current (rms) (2.5 × drive rated current) is processed as 100%
4 Output voltage (2 × motor rated voltage) is processed as 100%
5 DC bus Voltage 450 V (900 V)=100%
6 Power factor
-1.000
–1.000=100%
7 Power (2 × drive rated power) is processed as 100%
8 Output torque Full-load torque = 100%
9 AVI
0
–10 V = 0–100%
10 ACI
4
–20 mA = 0–100%
11 AUI
-10
–10 V = 0–100%
12 Iq current command (2.5 × drive rated current) is processed as 100%
13 Iq feedback value (2.5 × drive rated current) is processed as 100%
14 Id current command (2.5 × drive rated current) is processed as 100%
15 Id feedback value (2.5 × drive rated current) is processed as 100%
18 Torque command Motor rated torque = 100%
19 PG2 frequency command
Maximum operation frequency (Pr.01-00) is processed as
100%.
20 CANopen analog output
For CANopen communication analog output
Terminal Address
AFM1 2026-A1
AFM2 2026-A2
AO10 2026-AB
AO11 2026-AC