5. Fault Diagnostic Methods
5-7
Alarm Reset
After the cause of the alarm is cleared from the tripped state, press the RESET button on the keypad
(as shown in the figure), set the external terminal as a "Error Reset Command” and then connect the
terminal, or send error reset command through the communication port to release the tripped state of
the machine. Before rest any error alarm, the operation signal should be open (OFF) so as to prevent
the sudden running of the machine immediately after the recovery from error signal and causing
damage or injury.
U
F
H
KPV-CE01
JOG
RUN
RESET
STOP
PU
EXT PU
To Next Page
Loading...