What to do if I have wiring issues with my Delta Servo Drives?
If you're experiencing issues with Delta Servo Drives due to improper wiring, ensure all screws are securely fastened during installation. If the machine malfunctions, do not attempt to repair it yourself. Return the product to the dedicated service center for repair.
How to prevent dust issues with Delta VFD110VL43A-J?
To address dust issues with Delta Servo Drives, install the inverter in a dedicated cabinet and use a dust-proof cover. Regularly clean the inverter to ensure proper heat dissipation.
How to prevent corrosion in Delta VFD110VL43A-J?
To prevent corrosion issues with Delta Servo Drives, install the inverter in a dedicated cabinet and prevent liquids from flowing into it. Perform regular cleaning to avoid corrosion damage.
How to prevent oil contamination in Delta Servo Drives?
To mitigate oil contamination issues with Delta Servo Drives, install the inverter in a dedicated cabinet, keeping it away from potential oil spills. Regularly clean the inverter to prevent oil damage.
Why are the multi-function input/output terminals not working on my Delta VFD110VL43A-J?
If your Delta Servo Drives are experiencing issues with multi-function input/output terminals, it's likely due to exceeding their specifications. Refer to the operation manual for the rated voltage and current of the I/O contacts, and ensure you do not exceed these limits.
What to do for lint issues in Delta VFD110VL43A-J?
To resolve lint issues with Delta Servo Drives, install the inverter in a dedicated cabinet. Regularly clean the inverter to prevent lint accumulation.
Detailed specifications for the 230V and 460V series of Hybrid servo drives.
Guidelines for installing the Hybrid servo drive under specific environmental conditions.
Identification and explanation of terminals on the main circuit of the drive.
Explanation of terminals and modes for the control circuit of the drive.
Step-by-step guide for adjusting motor parameters using the digital keypad.
Overview table of system, motor, protection, and I/O parameters.
Troubleshooting flowchart for over current faults (ocA, ocd, oc).
Troubleshooting flowchart for ground fault (GFF).
Troubleshooting flowchart for over voltage (OV) faults.
Troubleshooting flowchart for low voltage (Lv) faults.
Troubleshooting flowchart for over heating (oH1) faults.
Troubleshooting for overload (oL) condition of the hybrid servo drive.
Troubleshooting flowchart for phase loss (PHL) faults.
General| Series | VFD-VL |
|---|---|
| Protection Level | IP20 |
| Cooling Method | Forced air cooling |
| Input Voltage | 3-phase, 380-480V AC |
| Control Method | Sensorless Vector Control |
| Protection Functions | Overheat |
| Communication Interface | RS-485 |
| Operating Temperature | -10°C to +50°C |
| Humidity | 90% RH, non-condensing |
| Altitude | Below 1000 m |
To Next Page