Delta VFD7A5MS21ANSAA - Page 317

Chapter 12 Descriptions of Parameter SettingsMS300
308
17: Count value reached, does not return to 0 (Pr.02-20)
12-1-1-70
18: Count value reached, return to 0 (Pr.02-19)
12-1-1-71
19: External interrupt B.B. input (Base Block)
12-1-1-72
20: Warning output
12-1-1-73
21: Over-voltage
12-1-1-74
22: Over-current stall prevention
12-1-1-75
23: Over-voltage stall prevention
12-1-1-76
24: Operation mode
12-1-1-77
25: Forward command
12-1-1-78
26: Reverse command
12-1-1-79
29: Output when frequency ≥ Pr.02-34
12-1-1-80
30: Output when frequency < Pr.02-34
12-1-1-81
31: Y-connection for the motor coil
12-1-1-82
32: -connection for the motor coil
12-1-1-83
33: Zero speed (actual output frequency)
12-1-1-84
34: Zero speed including STOP (actual output frequency)
12-1-1-85
35: Error output selection 1 (Pr.06-23)
12-1-1-86
36: Error output selection 2 (Pr.06-24)
12-1-1-87
37: Error output selection 3 (Pr.06-25)
12-1-1-88
38: Error output selection 4 (Pr.06-26)
12-1-1-89
40: Speed reached (including STOP)
12-1-1-90
42: Crane function
12-1-1-91
43: Actual motor speed detection
12-1-1-92
44: Low current output (use with Pr.06-71–Pr.06-73)
12-1-1-93
45: UVW output electromagnetic valve switch
12-1-1-94
46: Master dEb output
12-1-1-95
50: Output control for CANopen
12-1-1-96
51: Analog output control for RS-485 interface
12-1-1-97
52: Output control for communication cards
12-1-1-98
53: Fire mode indication
12-1-1-99
66: SO output logic A
12-1-1-100
67: Analog input level reached
12-1-1-101
68: SO output logic B
12-1-1-102
73: Over-torque 3
12-1-1-103
74: Over-torque 4
12-1-1-104
75: Forward RUN status
12-1-1-105
76: Reverse RUN status
12-1-1-106
 Use this parameter to set the function of multi-function terminals.