To Next PageTo Next Page
Need help?Do you have a question about the Delta VFD7A5ME21ANNAA and is the answer not in the manual?
Details about the drive's nameplate, including model, input voltage, and certifications.
Explanation of the model name coding for Delta drives, detailing series, voltage, and features.
Details on the RFI jumper's role in EMC filter performance and protection against surges.
Provides physical dimensions for Frame A models, including mounting hole specifications.
Provides physical dimensions for Frame B models, including mounting hole specifications.
Specifies required clearances for single drive, side-by-side, and zero stack installations for proper heat dissipation.
Illustrates the electrical connections for power input, output, and optional components.
Critical safety guidelines and checks to perform after completing wiring to avoid mistakes.
Shows the schematic of the main circuit connections, including power and motor terminals.
Details on ring lug specifications, wire gauge, and screw torque for main circuit terminals.
Guidance on using shielded wiring and twisted-pair wires for analog signals to reduce noise.
Details on connecting MI1-MI5 terminals, including Sink and Source modes.
Selection guide for brake resistors and units based on motor specifications and braking torque.
Table listing recommended breaker ratings for various AC motor drive models.
Introduction to KPC-CC01 and KPC-CE01 keypads, including communication settings and functions.
Step-by-step guide for installing option cards, including connector mounting and screw fastening.
Technical specifications for 115V one-phase models, covering output rating, input rating, and weight.
Overview of control characteristics, application macros, protection features, and certifications.
Guidelines for operating, storing, and transporting the drive, including temperature, humidity, and altitude limits.
Description of the keyboard layout, display areas, and functions of each key for navigation and operation.
Summary of drive parameters, including identity code and parameter reset functions.
Details on motor frequency, voltage, and acceleration/deceleration time settings.
Detailed explanations of all parameters, including their settings, defaults, and functions.
Flowcharts and procedures for adjusting motor parameters and performing start-up tests.
Lists warning codes, their descriptions, and corrective actions for communication errors and unsupported objects.
Comprehensive list of fault codes, their displays, names, descriptions, and corrective actions.
Explanation of the STO function, its purpose, and compliance with international safety standards.
Details on STO related terminal functions, including signal inputs, output voltage, and activation/cut-off modes.
Illustrates the internal circuit diagram and wiring for the safe control loop and STO mode.
Lists STO error codes, their descriptions, and troubleshooting steps for common issues.
General
