Deltec PowerRite Pro - Move the ON;OFF Switch to ON. Wait several seconds while the UPS performs the initial internal self-diagnostics.; Wait for the green ON, Line OK, and Battery Charging LEDs to light up...

-
14 Section 2 • Installation
-
0 Move the ON/OFF Switch lo ON. Wait several
seconds while the UPS performs the initial internal
self-diagnostics.
UPS ON/OFF Switch
ON
OFF
0
0 Wait for the green ON, Line OK, and Battery
Charging LEDs to light up on the front panel of
the UPS. Push the Alarm Silence/Reset button if
any red LEDs turn on. If any red LEDs remain on,
see section 3, Operation for instructions.
ON LED
{Green}
L/NEOK
LED {Green}
You hove now completed installation.
BATTERY
Charging LEDs
{Green)
Alarm
Silence/Reset
Button
It takes approximately 2..4 hours for the UPS to fully
charge the batteries after installation or long
storage. Until fully charged, the battery indicators
and measurements will not be accurate.