2. Safety and Protection information
H-110-200E V00 Page 8
2. Safety and protection information
General safety & application guidelines
1) It is not allowed to clean asbestos containing surfaces with high-pressure, unless using
special equipment.
2) Persons under the influence of alcohol, drugs or medicine should not operate the machine.
3) Do not touch plug and socket with wet hands.
4) This machine has been constructed for use with Nilfisk-ALTO detergents. The use of
other detergents or chemicals may cause problems as to the operation and the safety.
5) When using detergents the instructions should always be strictly observed.
6) Always flush the machine with clean water after use of chemical/detergents.
7) Always unplug power supply when cleaning and maintaining the machine.
8) Do not use machine if important parts are damaged – i.e. safety devices, high-pressure
hoses, spray handle.
9) The user is obliged to observe all national working environment and working safety
regulations concerning “operation of high-pressure washers”.
10) It is not allowed to connect this machine directly to a potable water supply.
11) If the machine is to be connected to potable water supply it is strictly necessary to fit the
machine with a water break tank, in accordance with EN1717.
Safety devices
The machine is equipped with the following safety devices:
1) Stop button. The stop button stops the machine when pushed.
2) Locking device on spray-gun handle. The locking device prevents the trigger from being
activated when pulled out.
3) Thermal sensor and over load relay protects the motor against overloading. The machine
can be switched on again after a few minutes, when the sensor has cooled.
4) Burner safety devices; the burner safety device protects the machine against faulty
ignition.
To Next Page
Loading...
