Speaker Connection
Selects which speaker and/or pre-out terminals to use for each channel.
o
Select the connection
Speaker + Pre-out
(Default):
Speaker and pre-out outputs are active.
Pre-out Only:
Pre-out outputs are active. Speaker
outputs are disconnected for enhanced
audio quality using only the pre-out
terminals.
0
This can not be set when “Amp Assign” is set to “Preamplifier” or “Custom”.
(v p. 215)
Speaker Preset
Two speaker settings can be saved to suit the environments where you
use your speakers.
For example, you can configure two presets easily to switch between
equalizer or speaker settings measured using Audyssey
®
Setup if the
characteristics of your room differ depending on factors such as whether
you use the screen.
If you want to use a preset, select the preset you want to use and then
configure settings such as Audyssey
®
Setup or the speaker settings to
save those settings to the preset you have selected.
Speaker Preset 1
(Default):
Saves the settings to Preset 1.
Speaker Preset 2: Saves the settings to Preset 2.
0
The following settings are saved to presets.
0
“Amp Assign” settings
0
“Speaker Configuration” settings
0
“Distances” settings
0
“Levels” settings
0
“Crossovers” settings
0
“Bass” settings
0
“2ch Playback” settings
0
“Front Speaker” settings
0
“MultEQ
®
XT32” data
0
“Graphic EQ” data
0
This setting also be configured using “Speaker Preset” in the option menu.
(v p. 126)
Contents
Connections Playback Settings Tips Appendix
242
Front panel Display Rear panel Remote Index
To Next Page
Loading...
Need help?
General
