EasyManuals Logo

Denon AVC-A1H User Manual

Denon AVC-A1H
341 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #278 background imageLoading...
Page #278 background image
No sound comes out of a specific speaker.
0
Check that speaker cables are properly connected.
0
Check that a selection other than “None” is set for the “Speaker Configuration” setting in menu. (v p. 225)
0
Check the “Assign Mode” setting in the menu. (v p. 213)
0
When the sound mode is “Stereo” and “Virtual”, audio is only output from the front speakers and subwoofer.
0
Audio is not output from the surround back speaker if “Speaker Virtualizer” is set to “On” when “Speaker Configuration” - “Surround Back” is set to “1
spkr” in the menu. (v p. 173)
0
Audio is not output from the front wide speaker if “Speaker Virtualizer” is set to “On”. (v p. 173)
0
When “Speaker Configuration” - “Surround Back” is set to “2 spkrs”, “Speaker Configuration” - “Center” is set to “Large” or “Small”, and sound mode is
set to “IMAX DTS”, surround audio is output from the surround back speaker. Audio is not output from the surround speaker. (v p. 229)
No sound is produced from subwoofer.
0
Check the subwoofer connections.
0
Turn on the subwoofer’s power.
0
Set “Speaker Configuration” - “Subwoofer” in the menu to “1 spkr”, “2 spkrs”, “3 spkrs” or “4 spkrs”. (v p. 225)
0
When “Speaker Configuration” - “Front” in the menu is set to “Large”, depending on the input signal and the sound mode, no sound may be output from
the subwoofer. (v p. 225)
0
When no subwoofer audio signal (LFE) is included in the input signals, no sound may be output from the subwoofer. (v p. 236)
0
You can make the subwoofer always output sound by setting the “Subwoofer Output” to “LFE + Main”. (v p. 236)
DTS sound is not output.
0
Check that the digital audio output setting on the connected device is set to “DTS”.
Dolby Atmos, Dolby TrueHD, DTS-HD, Dolby Digital Plus audio is not output.
0
Make HDMI connections. (v p. 73)
0
Check the digital audio output setting on the connected device. On some devices, “PCM” is set by default.
Contents
Connections Playback Settings Tips Appendix
278
Front panel Display Rear panel Remote Index

Other manuals for Denon AVC-A1H

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Denon AVC-A1H and is the answer not in the manual?

Denon AVC-A1H Specifications

General IconGeneral
Channels15.4
Power Output150W per channel (8 ohms, 20Hz-20kHz, 0.05% 2ch Drive)
HDMI Outputs3
Audio FormatsDolby Atmos, DTS:X, Auro-3D, IMAX Enhanced
Wireless ConnectivityWi-Fi, Bluetooth
TypeAV Amplifier
IMAX EnhancedYes
8K/60Hz Pass-throughYes
4K/120Hz Pass-throughYes
HDR SupportHDR10, HDR10+, Dolby Vision, HLG
eARCYes
Phono InputYes
THD0.05%
Frequency Response10 Hz - 100 kHz
Input Sensitivity200 mV
Signal-to-Noise Ratio102 dB
EthernetYes
USB PortYes
Multi-Room AudioHEOS
Amplifier TypeClass AB

Related product manuals