Denon AVC-A1HD - Ipod Playback; Basic Operation; Listening to Music

55
Getting Started Connections Setup Remote Control Multi-Zone Information Troubleshooting
NOTE
• Depending on the type of iPod and the software version, some
functions may not operate.
• DENON will accept no responsibility whatsoever for any loss of iPod
data.
Listening to Music
1
Use ui to select the menu, then press ENTER or p
to select the music le to be played.
2
Press ENTER or p.
Playback starts.
To pause
During playback, press ENTER or [1].
Press again to resume playback.
Fast-forwarding or fast-reversing
During playback, either press and hold u (to fast-reverse) or i (to
fast-forward), or press [6] or [7].
To cue to the beginning of a track
During playback, either press u (to cue to the previous track) or i (to
cue to the next track), or press [8] or [9].
To stop
During playback, either press and hold ENTER or press [2].
Playing repeatedly
Press [CHANNEL –] or [REPEAT] on the sub remote control unit.
[Selectable items] All One OFF
:
”Source Select” – “(input source)” –
”Playback Mode (iPod)” – “Repeat” (vpage 43)
• With the default settings, the iPod can be used connected to the VCR
(iPod) connector.
• Use the RESTORER mode to expand the low and high frequency
components of compressed audio files and achieve a richer sound.
The default setting is “Mode3”.
• Press <ON/STANDBY> or [POWER OFF] and set the AVC-A1HD’s
power to the standby mode before disconnecting the iPod. Also
switch the input source to one to which the GUI menu “iPod dock”
is not assigned before disconnecting the iPod.
iPod
®
Playback
The music on an iPod can be played by using the Control Dock for
iPod (ASD-1R, sold separately).
The operation can also be performed using the buttons on the main
unit or remote control unit while watching the GUI menus.
iPod is
a trademark of Apple Inc., registered in the U.S.
and other countries.
b
The iPod may only be used to copy or play contents that are not
copyrighted or contents for which copying or playback is legally
permitted for your private use as an individual. Be sure to comply
with applicable copyright legislation.
1
Make the necessary preparations.
q Set the iPod in the DENON Control Dock for iPod.
(vSee the Control Dock for iPod’s operating instructions.)
w Assign the Control Dock for iPod’s input.
:
”Source Select” – “(input source)” – “Assign”–
”iPod dock” (vpage 44)
2
Either turn <SOURCE SELECT> or press [iPod] (AMP
mode) to select the input source assigned in step 1-w
above.
(iPod screen)
b If the screens above are not displayed, the iPod may not be
properly connected. Try connecting again.
:
”Source Select” – “(input source)” – “Play”
(vpage 43)
3
To operate using the main remote control unit, set the
remote control unit to the iPod mode.
(vpage 67 “Remote Control Unit Operations”)
OK to disconnect
Basic Operation
Playback
4
Press [SEARCH] and hold it down for a 2 seconds or
more to select the display mode.
To switch between modes, press and hold down the button.
When remote mode is active, “Remote” is displayed.
[Display mode]
Browse mode Remote mode
Display location Main unit display iPod display
Playable
files
Audio file
S S
Video
file
A S
z
Active
buttons
Remote
control unit
(AVC-A1HD)
S S
iPod
A S
z
: Video may not be output, depending on the combination of ASD-
1R and iPod.