How do I get Dolby TrueHD, DTS-HD, Dolby Digital Plus audio output on my Denon Av receiver?
To enable Dolby TrueHD, DTS- HD, and Dolby Digital Plus audio output on your Denon Av receiver, make HDMI connections.
Why can't I select Dolby PLg or DTS NEO:6 mode on my Denon Av receiver?
If you cannot select Dolby PLg mode or DTS NEO:6 mode on your Denon Av receiver, ensure that “Speaker Config.” – “Center” or “Surround” is set to something other than “None”. These sound modes are unavailable if the speaker system is 2.0/2.1ch. Also, Dolby PLg or DTS NEO:6 cannot be selected when headphones are in use.
General| Channels | 7.1 |
|---|---|
| HDMI Inputs | 6 |
| HDMI Outputs | 1 |
| Network Capability | Yes |
| HDMI Pass-Through | Yes |
| Audio D/A Converter | 192kHz/24-bit |
| Input Impedance | 47 kOhms |
| Input Sensitivity | 200 mV |
| Response Bandwidth | 10 Hz - 100 kHz |
| Signal-To-Noise Ratio | 100 dB |
| HDMI Switching | Yes |
| 3D Technology | Yes |
| Frequency Response | 10 Hz - 100 kHz |
| Total Harmonic Distortion | 0.08 % |
| Bluetooth | No |
| Audio Formats Supported | Dolby TrueHD, DTS-HD Master Audio |
| Streaming Services | AirPlay, Pandora |
| Dimensions (W x H x D) | 17.1 in x 6.6 in x 13 in |
| Surround Sound Effects | DTS Neo:6, Dolby Pro Logic IIz |
| Additional Features | Audyssey Dynamic EQ, Audyssey Dynamic Volume, Audyssey MultEQ XT |
| Inputs | HDMI input |
| Outputs | HDMI output |
| Video Upconversion | Yes |
| Power Output (8 ohms) | 95 W |
To Next Page
