EasyManua.ls Logo

Denon AVR-2105 - Service Manual

Denon AVR-2105
263 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
SERVICE MANUAL
MODEL
AVR-2105/885
AVC-1890
AV SURROUND RECEIVER / AMPLIFIER
Tokyo, Japan
X0206V.01 DE/CDM 0407
For U.S.A., Canada, Europe, U.K.,
Asia, China,Taiwan R.O.C., Korea
& Japan model
サービスをおこなう前に、このサービスマニュアルを
必ずお読みください。本機は、火災、感電、けがなど
に対する安全性を確保するために、さまざまな配慮を
おこなっており、また法的には「電気用品安全法」に
もとづき、所定の許可を得て製造されております。
従ってサービスをおこなう際は、これらの安全性が維
持されるよう、このサービスマニュアルに記載されて
いる注意事項を必ずお守りください。
本機の仕様は性能改良のため、予告なく変更する
ことがあります。
Please use this service manual with referring to the
operating instructions without fail.
Some illustrations using in this service manual are
slightly different from the actual set.
修理の際は、必ず取扱説明書を参照の上、作業を
行ってください。
本文中に使用しているイラストは、説明の都合上
現物と多少異なる場合があります。
補修用性能部品の保有期間は、製造打切後8年です。
注 意
For purposes of improvement, specifications and
design are subject to change without notice.
w
w
w
.
x
i
a
o
y
u
1
6
3
.
c
o
m
Q
Q
3
7
6
3
1
5
1
5
0
9
9
2
8
9
4
2
9
8
T
E
L
1
3
9
4
2
2
9
6
5
1
3
9
9
2
8
9
4
2
9
8
0
5
1
5
1
3
6
7
3
Q
Q
TEL 13942296513 QQ 376315150 892498299
TEL 13942296513 QQ 376315150 892498299
http://www.xiaoyu163.com
http://www.xiaoyu163.com

Table of Contents

Other manuals for Denon AVR-2105

Questions and Answers

  • J
    Joseph WalkerAug 14, 2025
    What to do if my Denon Stereo Receiver display is lit but no sound is produced?
    • S
      Scott MillerAug 14, 2025
      If the display is lit but no sound comes out of your Denon Stereo Receiver, consider these potential causes: * Speaker cords might not be securely connected; ensure they are properly connected. * The audio function button may be improperly positioned; adjust it to a suitable setting. * The volume control might be set to the minimum; increase the volume to an audible level. * MUTING may be activated; switch MUTING off. * If you've selected a digital input, ensure digital signals are being input, or select the correct input jacks.
  • O
    otaylorAug 17, 2025
    How to fix a Denon Stereo Receiver when the display is not lit and no sound is produced?
    • V
      victoria15Aug 17, 2025
      If the display isn't lit and no sound is produced when the power switch is on, check that the power cord is securely plugged in. If it is, try turning the power on with the remote control after switching the POWER switch on.
  • D
    Debra BrownAug 20, 2025
    Why is the power indicator flashing rapidly and the display not lit on my Denon Stereo Receiver?
    • S
      Sharon SuttonAug 20, 2025
      If the display is not lit and the power indicator is flashing rapidly on your Denon Stereo Receiver, it could be due to: * Short-circuited speaker terminals: Switch the power off, connect the speakers correctly, and then switch the power back on. * Blocked ventilation holes: Turn off the power, ventilate the unit to cool it down, and then turn the power back on once it's cooled. * Continuous high power operation and/or inadequate ventilation: Turn off the power, ventilate it well, and then turn it back on after it cools down.
  • T
    Timothy CrossAug 23, 2025
    Why is my Denon Stereo Receiver not responding to the remote control?
    • K
      Keith PhillipsAug 25, 2025
      If your Denon Stereo Receiver isn't responding to the remote control, check the following: * Dead batteries: Replace them with new ones. * Excessive distance: Move closer to the unit. * Obstacles: Remove any obstructions between the remote and the unit. * Incorrect button: Ensure you're pressing the correct button. * Incorrect battery insertion: Verify the batteries are inserted with the correct polarity (+ and -).
  • J
    juliafreemanAug 27, 2025
    What to do if sound is only coming from one channel on my Denon Stereo Receiver?
    • M
      michelequinnAug 27, 2025
      If sound is only coming from one channel on your Denon Stereo Receiver, the issue might be due to incomplete connections. Ensure that both the speaker cords and the input/output cords are securely connected.
  • W
    whitney60Aug 30, 2025
    Why is my Denon Stereo Receiver producing a humming noise when playing records?
    • A
      annefullerAug 31, 2025
      If your Denon Stereo Receiver is producing a humming noise while playing records, it could be due to: * The turntable's ground wire not being properly connected: Ensure it's securely connected. * An incomplete PHONO jack connection: Make sure the connection is secure.
  • W
    William GreenSep 2, 2025
    Why are the instrument positions reversed during stereo playback on my Denon Stereo Receiver?
    • C
      Curtis JensenSep 3, 2025
      If the instrument positions are reversed during stereo playback on your Denon Stereo Receiver, it's likely due to reversed connections of the left and right speakers or the left and right input/output cords. Check these connections to ensure they are correct.
  • M
    Micheal GonzalezSep 6, 2025
    Why does my Denon Stereo Receiver produce a howling noise when the volume is high?
    • M
      mannjenniferSep 6, 2025
      If your Denon Stereo Receiver produces a howling noise at high volumes, it could be because: * The turntable and speaker systems are too close together: Separate them as much as possible. * The floor is unstable and vibrates easily: Use cushions to absorb speaker vibrations transmitted through the floor. If your turntable lacks insulators, consider using audio insulators.
  • D
    David GarzaSep 9, 2025
    Why is the sound distorted on my Denon Stereo Receiver?
    • P
      Paula LeeSep 9, 2025
      If the sound from your Denon Stereo Receiver is distorted, consider the following: * Stylus pressure may be too weak: Apply the proper stylus pressure. * The stylus may be dirty: Check the stylus for dust or dirt. * The cartridge may be defective: Consider replacing the cartridge.

Summary

Service Manual

Service Precautions

Important safety and operational notes for servicing the unit, including reading the manual and following precautions.

Safety Precautions

Leakage Current Check Procedure

Procedure for checking leakage current or line-to-chassis resistance to ensure unit safety before customer return.

Block Diagram

Caution in Servicing

Initializing AV Surround Receiver

Procedure for initializing the AV surround receiver, including button combinations and expected outcomes.

Adjustment

Audio Section Adjustment

Procedure for adjusting the audio section, including preparation steps and mode settings.

Idling Current Adjustment

Detailed steps for adjusting idling current, including test points, voltage settings, and timing.

Video Section Adjustment (US, Canada, Japan)

Component Video Level Adjustment

Procedure for adjusting component video Y, Cb, and Cr levels using test disc and oscilloscope.

Printed Wiring Boards

CPU, Front PWB Unit

CNT, Pre-Amp PWB Unit

Input;Video PWB Unit (US, Canada, Japan Models)

DSP PWB Unit

D-Video PWB Unit (Japan Model)

Parts List of PWB Unit Assembly (USA & Canada)

CPU, Front PWB Unit Semiconductor Components (Parts List)

Parts List of PWB Unit Assembly (UK)

Main PWB Unit Parts List (UK)

List of semiconductor components (ICs, transistors, diodes) for the main PWB (UK version).

Parts List of PWB Unit Assembly (Japan)

Main PWB Unit Parts List (Japan)

List of semiconductor components (ICs, transistors, diodes) for the main PWB (Japan version).

Exploded View (USA, Canada Model)

Parts List of Exploded View (USA & Canada)

Main PWB Unit Parts List (USA & Canada)

List of parts corresponding to the exploded view for USA and Canada models.

Parts List of Exploded View (Europe, Asia & Korea)

Main PWB Assembly Parts List (Europe, Asia, Korea)

List of main PWB assembly parts for Europe, Asia, and Korea models.

Parts List of Exploded View (UK & China)

Main PWB Unit Parts List (UK & China)

List of main PWB unit parts for UK and China models.

Parts List of Exploded View (Taiwan R.O.C.)

Main PWB Unit Parts List (Taiwan R.O.C.)

List of main PWB unit parts for Taiwan R.O.C. models.

Parts List of Exploded View (Japan)

Wiring Diagram

Notes for Schematic Diagrams

Schematic Diagrams (1;16)

Schematic Diagrams (2;16)

Schematic Diagrams (3;16)

Schematic Diagrams (4;16)

Schematic Diagrams (5;16)

Schematic Diagrams (6;16)

Schematic Diagrams (7;16)

Main Unit Schematic

Schematic diagram of the main unit, showing major sections and their interconnections.

Schematic Diagrams (8;16)

Schematic Diagrams (9;16)

Schematic Diagrams (10;16)

Schematic Diagrams (11;16)

Schematic Diagrams (12;16)

Schematic Diagrams (13;16)

Schematic Diagrams (14;16)

Schematic Diagrams (15;16)

Schematic Diagrams (16;16)

Denon AVR-2105 Specifications

General IconGeneral
Power Output90 W per channel (8 ohms, 20 Hz - 20 kHz, 0.08% THD)
Number of Channels7.1
Component Video Inputs3
AM/FM TunerYes
Response Bandwidth10 Hz - 100 kHz
Signal-To-Noise Ratio102 dB
THD0.08%
Input Impedance47 kOhm
Input Sensitivity200 mV
Tuner BandsAM/FM
Digital Sound Processor (DSP)Yes
HDMI SwitchingNo
Video Conversion/ScalingNo
Output Impedance / Channel8 ohm
Frequency Response10 Hz - 100 kHz
Total Harmonic Distortion0.08%
Dolby DecodingDolby Digital, Dolby Pro Logic II
DTS DecodingDTS, DTS Neo:6
Digital Audio Inputs2 coaxial, 5 optical
Audio D/A Converter24bit / 192kHz
Tuner Frequency RangeAM: 522 - 1611kHz, FM: 87.5 - 108MHz
Dimensions (W x H x D)434 x 171 x 377 mm
Output Power / Channel90W (8 ohms, 20Hz-20kHz, 0.08% THD)

Related product manuals