Denon AVR-2307CI

PageDefault settingsItems
PageDefault settingsItems
Set whether or not to store the surround mode last played for the input
signal.
Advanced Setup – Part 1 Advanced Setup – Part 1
47
ENGLISH
ENGLISH
5. Advanced Playback
1
2ch
Direct/Stereo
Auto Surround
Mode
3
Basic
Auto Surround Mode = ON
56
57
6. Option Setup
1
Power Amp
Assign
58
S. Back
59
2Volume Control
Setup Lock
58
Vol.Limit = OFF
P. On Lev. = LAST
Mute Lev. = FULL
Setup Lock = OFF
Main
4
Make the 2-channel direct mode and stereo mode speaker settings.
To suit your preference, a surround back channel’s power amplifier can be
assigned to the front channel (“Front A” or “Front B”) for bi-amp
playback, ZONE2.
This sets the volume level of output.
This sets whether or not to lock the system setup settings so that they
cannot be changed.
2
Dolby Digital
Setup
OFF
56
Turn the audio compression on or off when down-mixing Dolby Digital
signals.
4
Manual EQ
Setup
All Channels and Frequency = 0 dB
57
Adjust the tone of the various speakers while listening to the playback
signals.
3Trigger Out 59
ZONE = MAIN, All Surround Modes = ON
Trigger Out
1
Use the DC 12 V output of the AVR-2307CI’s two trigger
out jacks in association with the various input sources and
surround modes.
Trigger Out
2
TUNER
OFF
PHONO
OFF
CD
OFF
CDR /
TAPE
OFF
DVD /
VDP
ON
TV /
DBS
ON
VCR-1
ON
VCR-2
ON
V. AUX
ON
ZONE = 2
TUNER
ON
PHONO
ON
CD
ON
CDR /
TAPE
ON
DVD /
VDP
ON
TV /
DBS
ON
VCR-1
ON
VCR-2
ON
V. AUX
ON