Denon AVR 4308CI - AV Network Receiver - Page 20

- 20 -
※ANALOG TUNER Control
COMMAND PARAMETER
function example
TF
ANUP
TUNER Frequency UP/DOWN
TFANUP<CR>
ANDOWN TFANDOWN<CR>
AN******
(6 digits)
--- ****.** kHz at AM band (>050000 is AM.)
****.** MHz at FM band (<050000 is FM.)
TFAN105000<CR>
(1050.00kHz at AM)
AN?
Return TF Status
TFAN?<CR>
TP
ANUP
TUNER PRESET CH UP/DOWN , direct change to No.**
TPANUP<CR>
ANDOWN TPANDOWN<CR>
AN**(PRESET
No.)
TPANA1<CR>
(PRESET No.”A1”)
AN?
Return TP Status
TPAN?<CR>
ANMEMORY
TUNER PRESET MEMORY
TPANMEMORY<CR>
TM TUNER BAND , MODE Select
ANAM
---Band set to AM
TMANAM<CR>
ANFM
---Band set to FM
TMANFM<CR>
AN?
Return TM Status
TMAN?<CR>
ANAUTO
---Tuning mode set to AUTO mode
TMANAUTO<CR>
ANMANUAL
---Tuning mode set to MANUAL mode
TMANMANUAL<CR>
TF, TP, TM COMMAND : '*' parameters can NOT operate when INPUT source isn’t TUNER.