Use the 0 (left) and 0 fright) buttons to assign the input function connected to the OPTICAL input 2
(OPTICAL 2) terminal.
(Initial)
.: :-.
. . . . :..., ..:.. ,..., ..:.. : :
: :
.!. .::..
; i &.’ ; : i i ;
. . . . . . .::.. : ...
@- -0
(left) button (right) button
l Select “OFF” If nothrng is connected.
Press the ENTER or a (down) button to switch the auto surround mode setting.
NOTE:
l TUNER, V. AUX cannot be selected.
For the three kinds of input signals as shown below, the surround mode played the last is stored in the memory. At next time it the same signal
inputs, the memorized surround mode is automatically selected and the signal is played.
Note that the surround mode setting is also stored separately for the different input function.
I
1 SIGNAL 1 Default Auto Surround Mode 1
@ Analog and PCM 2-channel signals STEREO
@ 2-channel signals of Dolby Digital, DTS or other multichannel format Dolby PLII Cinema
@
Multichannel signals of Dolby Digital, DTS or other multichannel format Dolby or DTS Surround
1
QQ?
Use the 0 (left) and 0 (right) buttons to select the Auto Surround mode.
4 b
(Initial)
.: . . . . . . . . .
: . .
~...~ ~ : -a- .-: :-- i ; i1-1: 11-3
: : :
:“‘E ;. i
p-jp-j
.L . . . . .
: -. :
f ::...: ! L.. ..,. “..:: ‘.FY ::
;,,,; ! y
. .
(I- 0
- -1
(left) button (right) button
Press the ENTER or 4B (down) button to switch the Ext. In SW Level setting,
Set the method of playback of the analog input signal connected to the Ext. In terminal.
1
O&
Use the 0 (left) and 0 (right) buttons to select the Ext. In Subwoofer channel Level playback.
4
b
(Initial)
.i ,.;
yy :,;: y- ‘< i,, ;
: :
:..., { : ;
,: ~..
~~~1~1
.:.
:-i I.... :‘.: : :: .L ! ‘! “.‘..
.+. i --:
.:. ‘....
@- -0
(left) button (right) button
Press the ENTER or Q (down) button if you want to start the settings over from the beginning
22
To Next Page
Loading...
Need help?
General
