Denon AVR-884 User Manual (English)

Other manuals for Denon AVR-884

Questions and Answers:

L
Lawrence GoodAug 13, 2025
What to do if the Denon AVR-884 display is lit but no sound is produced?
- J
  jessica75Aug 13, 2025
  If the display is lit on your Denon Stereo Receiver, but you're not getting any sound, there are several potential causes: * Check if the speaker cords are securely connected. * Ensure the audio function button is in the correct position. * Verify the volume control is not set to the minimum; increase it to a suitable level. * Make sure MUTING is switched off. * If using digital input, confirm digital signals are being input or select the correct input jacks.
S
Stacey HurstAug 16, 2025
Why is there no sound and the display is not lit on my Denon Stereo Receiver?
- Q
  qwatersAug 16, 2025
  If the display is not lit and no sound is produced when the power switch is on for your Denon Stereo Receiver: * Check that the power cord is securely plugged in. * After turning the POWER switch on, try turning the power on with the remote control.
D
Dennis CookAug 21, 2025
Why is the Denon Stereo Receiver display not lit and the power indicator flashing rapidly?
- M
  Michele Martin MDAug 21, 2025
  If the display is not lit and the power indicator is flashing rapidly on your Denon Stereo Receiver, this could be due to: * Short-circuited speaker terminals: Switch the power off, connect the speakers properly, and then switch the power back on. * Blocked ventilation holes: Turn off the power, ventilate the unit well to cool it down, and then turn the power back on. * Continuous high power operation with inadequate ventilation: Turn off the power, ventilate the unit well to cool it down, and then turn the power back on.
A
andersonmichelleAug 25, 2025
How to fix a Denon AVR-884 Stereo Receiver that is not operating properly with the remote control?
- C
  caleb02Aug 25, 2025
  If your Denon Stereo Receiver isn't responding to the remote control, try these solutions: 1. Replace the batteries with new ones. 2. Move the remote control closer to the unit. 3. Remove any obstacles between the remote and the unit. 4. Ensure you are pressing the correct button. 5. Verify the batteries are inserted correctly, with the < and > ends in the proper orientation.