EasyManuals Logo

Denon AVR-X3300W User Manual

Denon AVR-X3300W
296 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #207 background imageLoading...
Page #207 background image
Network
To use this unit by connecting it to a home network (LAN), you must configure network settings.
If you set up your home network (LAN) via DHCP, set “DHCP” to “On”. (Use the default setting.) This allows this unit to use your home network (LAN).
When assigning an IP address to each device manually, you need to assign an IP address to this unit using the “IP Address” settings, and enter
information about your home network (LAN) such as the gateway address and subnet mask, etc.
Information
Display network information.
Friendly Name / Connection / SSID / DHCP / IP Address / MAC
Address
0
MAC Address is required to create a vTuner account.
Connection
Choose whether to connect the home network to a wireless LAN or a
wired LAN.
When connecting to the network using wired LAN, select “Wired
(Ethernet)” after connecting a LAN cable,
When connecting to the network using wireless LAN, select “Wireless (Wi-
Fi)” and configure the “Wi-Fi Setup”. (v
p. 208)
o
Wi-Fi
You can stop the Wi-Fi function when connecting this unit to the
network using Wired LAN.
Enabled
(Default):
The Wi-Fi function is used.
Disabled: The Wi-Fi function is stopped.
Contents Connections Playback Settings Tips Appendix
207
Front panel Display Rear panel Remote Index

Table of Contents

Other manuals for Denon AVR-X3300W

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Denon AVR-X3300W and is the answer not in the manual?

Denon AVR-X3300W Specifications

General IconGeneral
Receiver typeSurround
Frequency range10 - 100000 Hz
Pre-out channels7.2
Pre-out connectivityYes
Audio output channels7.2 channels
Signal-to-Noise Ratio (SNR)100 dB
Total Harmonic Distortion (THD)0.05 %
Power output per channel (1KHz@6 Ohm)180 W
Power output per channel (20-20KHz@8 Ohm)105 W
AC input voltage230 V
AC input frequency50 Hz
Power consumption (standby)0.1 W
Power consumption (typical)600 W
Product colorBlack
Audio decodersDTS-HD, DTS-HD Master Audio, Dolby TrueHD
Multi-Zone quantity2
Apple docking compatibility-
AM band range522 - 1611 kHz
FM band range87.5 - 108 MHz
Supported radio bandsAM, FM
HDMI in8
Audio (L/R) in5
Remote control in1
Composite video in3
Composite video out0
Connectivity technologyWired
Speakers connectivity typeClamp terminals
Audio formats supportedAAC, AIFF, ALAC, DSD, FLAC, MP3, WAV, WMA
Weight and Dimensions IconWeight and Dimensions
Depth389 mm
Width434 mm
Height167 mm
Weight10800 g

Related product manuals