4.4. Click on “Choose File” and navigate to the location where you saved the config file. Select it, and then click
“Upload.”
4.5. The laptop should display an "Uploading" message in the lower left corner of its display. Once the file is
uploaded to the AVR (~ 30 seconds), the AVR will power to Standby and display "Loading" on the front panel
display. The LOAD process will take about 6 minutes.
4.6. If the LOAD has completed successfully, a “Load Completed” image should be displayed on your laptop
and the AVR will power back ON again (Yeh!).
4.7. Perform a “soft reset” (unplug power for 5 minutes) after LOAD.
djl 18 March 2017
To Previous Page
Loading...
